Bob's WLC Project

[bob42wlc]

Thanks Todd,

But I'd like to know how the cable gets oiled..........how does the oil get to the wire???

[Mr. Big]

The oil is where it is, but is not where it isn't and will deviate to where it's needed and not where it was......

[tomcat1]

Thanks Todd,

But I'd like to know how the cable gets oiled..........how does the oil get to the wire???

you remove a small amount of the housing. I will post picture

[Rubone]

Bob,
When the oiler is installed the casing needs to be cut open so that when the oil is pumped past the spring loaded check valve it fills the void and then works its way past the coiled inner casing to the solid wire within.
Robbie

[tomcat1]

[bob42wlc]

Hi guys,

Just want to thank everybody, in one way or another, who reply to my questions and help me with my project. You ROCK, old bikes pros!!!

[Mr. Big]

Mailed the muffler Thursday. Let me know when you get it.

[bob42wlc]

Mailed the muffler Thursday. Let me know when you get it.

Hi guys,

I just wanna thanks everybody who send me OEM parts for free! You guys ROCK!!!!

[bob42wlc]

Hi guys,

Just wanna know how I determine my intake manifold is fine or the packings need to be replaced. Tried to take the bushings out but couldn't. I read in Palmer's and my maunal but didn't get it. Must admit I didn't read patiently tho...........

[Rubone]

Bob,
Best thing to do is bolt it up and do a leak test on it. If they are airtight they are fine. If you need to replace them you might consider Peek seals for it.
Robbie