Results 1 to 5 of 5

Thread: Brass intake seal angle

  1. Brass intake seal angle

    Hoping Mr. Cotten will see this. Looking to re-cut the angle on the plumbers' nuts that bear against the brass intake seals. Are the 2 angles the same, or is the nut angle a tad steeper? For instance, are both angles 45 degrees, or whatever, or would the seal angle be 45 and the nut angle, say, 46 or 47?

  2. Re: Brass intake seal angle

    I get 57 degrees on the seal and 60 degrees on the nut.

  3. Re: Brass intake seal angle

    Those angles would be measured perpendicular to the tube, and not along the axis, right?

  4. Re: Brass intake seal angle


  5. Re: Brass intake seal angle

    Got it.....Thanks

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Brass Intake Manifolds
    By bianese in forum Harley 1936-1964
    Replies: 21
    Last Post: 07-23-2015, 10:20 AM
  2. 1916 Model-F how to seal the intake housing
    By wkuehnis in forum Harley Pre 1936
    Replies: 8
    Last Post: 12-06-2013, 09:47 AM
  3. Filling Yellow Brass With Brass
    By Paps in forum Sheet Metal, Paint & Finish
    Replies: 27
    Last Post: 11-15-2013, 09:24 AM
  4. Brass intake ??
    By Jimmy the saint in forum Harley 1936-1964
    Replies: 11
    Last Post: 11-22-2010, 09:51 AM
  5. Brass Intake Seal Removal
    By Pigpen in forum Harley 1936-1964
    Replies: 11
    Last Post: 11-14-2009, 09:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •