Page 2 of 15 FirstFirst 123412 ... LastLast
Results 11 to 20 of 150

Thread: UL Rider

  1. Re: UL Rider

    I'll be using an RL front end because I have one. It's not a direct replacement, it will need modifications. First, it's got to be straightened. A hydraulic press does much of the work, and I made a simple tool to do the final tweaking.
    https://imagizer.imageshack.com/v2/2...922/V2kUux.jpg
    The front fork bends fairly easily, but the rear is forged and tempered. It's like trying to straighten a spring. Alignment needs to be near perfect or the rockers will bind.

  2. Re: UL Rider

    The spring guide rods on an RL front end are about an inch shorter than a Big Twin and need to be changed. Also, the holes at the bottom of the forks must be enlarged to 1/2" to accept Big Twin rockers. Two easy jobs. However, the stem is also too short and a special nut has to be made. A straightforward job on a small lathe.

    The nut has a 1" OD and the ID is tapped for 7/8-24. I'll be using Timken bearings because that is the easiest way to go. The lower will be #07093, a trailer bearing, and the upper #07100, Hydra Glide.
    Attached Images Attached Images

  3. Re: UL Rider

    Powder coating front end.

  4. Re: UL Rider

    Front end assembled

  5. Re: UL Rider

    Using a wheel truing stand to check runout on drum and sprocket.


  6. Re: UL Rider

    Wheels built and balanced.Attachment 23344

  7. #17

    Re: UL Rider

    I get invalid attachment. I was going to ask how the sprocket ran when you checked the run out on it butt it slipped my mind.

  8. Re: UL Rider

    Sorry, the attachment works on my computer. I've been having problems ever since Microsoft did a major update. The sprocket was pretty close. They're never perfect.Attachment 23345

  9. #19

    Re: UL Rider

    I still get invalid attachment

  10. Re: UL Rider

    Now I don't know what to do.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. New Rider
    By Fiona01 in forum New Member Intro
    Replies: 0
    Last Post: 06-07-2012, 08:22 AM
  2. Iowa Rider
    By wuzfuz in forum New Member Intro
    Replies: 6
    Last Post: 06-13-2009, 04:43 PM
  3. old Pa. rider.
    By cruizenvett in forum New Member Intro
    Replies: 5
    Last Post: 04-05-2008, 07:59 PM
  4. A Harley rider and an Indian rider
    By chiefrider in forum Humor
    Replies: 0
    Last Post: 01-30-2008, 11:52 AM
  5. Cc Rider
    By chiefj48 in forum General Motorcycle Discussion
    Replies: 9
    Last Post: 01-11-2008, 04:01 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •