Results 1 to 1 of 1

Thread: Fork stem ?

  1. Fork stem ?

    so , I taped the bearing cup's out from my frame , & they measure 1.187 on the part that go's into the frame . The stem on the aftermarket springer measured 15/16 .There is a slight step in the head just past where the bearing cups bottom out & it measures @ 1.03 . I have attached a few pic's ,(if it works for me ) I'm pretty sure it's not a stock head on my frame , didn't think the stock one had a taper on top & bottom . I still need to bust out more bondo from the moulding job so I can see how the head was attached . I think with the measurements I have I will not be able to put a stock WG front end on with the 1" stem. I contacted Rullo today about the cup's I sent the link in for &they emailed me the measurement & was told the od on their cup is 1.8 , I will call back tomorrow to verify , there were tapered Timken installed with a id of .9375 , # L44640 . any input would be appreciated . I plan to go to a swap meet in Sacramento on Sat if I learn anything
    Attached Images Attached Images
    "it the thunder don't get ya , the lightning will"

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 36EL Top fork stem nut finish?
    By harleytoprock in forum 1936 Harley EL Knucklehead
    Replies: 10
    Last Post: 01-11-2017, 11:06 PM
  2. Fork neck stem
    By nmaineron in forum Wheel, Tire, Frame & Suspension
    Replies: 4
    Last Post: 03-19-2012, 09:29 AM
  3. Servi Car fork stem size
    By rdillon in forum Sidecar & Trike
    Replies: 5
    Last Post: 12-21-2011, 06:10 AM
  4. Fork Stem
    By Bigincher in forum Harley 1936-1964
    Replies: 20
    Last Post: 11-28-2010, 08:30 PM
  5. fork stem bearings
    By larry harding in forum Harley 1936-1964
    Replies: 22
    Last Post: 03-17-2009, 07:52 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •